civet_installation_on_vm
====== Differences ====== This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
civet_installation_on_vm [2015/04/13 15:30] 132.216.122.19 |
civet_installation_on_vm [2015/04/24 19:00] 132.216.122.19 |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| These are my notes in my attempt to compile CIVET (a version updated by Daan in February 2015) on a VM running CentOS 6.5: | These are my notes in my attempt to compile CIVET (a version updated by Daan in February 2015) on a VM running CentOS 6.5: | ||
| - | 1. Install Getopt:: Tabular from cpan | + | **1.** When copying the code if links or files in the folder SRC are missing it is ok. You can ignore. All other soft links should be working though. |
| + | |||
| + | **2.** Need to make sure to source the init.sh file | ||
| + | >source /quarantine/init.sh | ||
| + | |||
| + | **3.** For my installation I also needed to install Getopt:: Tabular from cpan | ||
| >cpan | >cpan | ||
| >install Getopt::Tabular | >install Getopt::Tabular | ||
| >quit | >quit | ||
| + | but that was before I sourced the init.sh file so that might not be necessary | ||
| + | |||
| + | **4** Because the ssh connection times out, you should install and use screen to run CIVET | ||
| + | >yum -y install screen | ||
| + | >screen | ||
| + | Then run the program. If outside screen you can go back to screen by typing; | ||
| + | >screen -r | ||
| + | Then based on the detached screens choose which one to attach: | ||
| + | >screen -r xxxxx.penelope | ||
| + | for example | ||
| - | 2. | ||
civet_installation_on_vm.txt · Last modified: 2016/11/03 17:23 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
